Office Gaming Chair Heavy Duty Gas Pneumatic Hydraulic Lift Cylinder Replacement

page not found

Each order is for 1 piece of HEAVY DUTY Gas lift cylinder that holds 150kg (330 pound)Fits most office, executive, computer, and gaming chairs.SGS, BIFMA, and EU EN1335 safety rating, tested and certifiedSpecifications:- Material: Steel- Outer Cylinder Diameter: 2"- Inner Cylinder Diameter: 1.1"- Minimum Length approx: 10"- Length when fully extended approx: 15"- Support Capacity: 330 lbsHow to make sure the gas lift cylinder fits your office chair?Check the outer and inner diameter of your broken gas lift cylinder.This replacement part fits the one with an outer diameter of 2" and inner diameter of 1.1".Full 360 degree rotation, smooth and noiseless movements to all directionsHow to remove the damaged cylinder?1. Tip the chair onto its side2. Spray WD-40 lubricant around the join of cylinder, base and mechanism3. Let the lubricant sit for a few minutes4. Use rubber hammer to tap and remove the cylinder from the base and the mechanism To install the new cylinder:The thick part of the cylinder sits on the base, while the thin chrome part goes in to the mechanism. The parts will then fasten on their own. Package Content: - 1 Gas Lift Cylinder with no other accessoryOuter cylinder: 2 inches, Inner cylinder: 1.1 inches. Please confirm the measurement before ordering. Telescoping Cylinder Dust Shroud Cover is available to purchase (please use the pull down menu)4.5 inch height with extension to 11 inch total heightFits cylinder with 2" outer cylinder and 1.1" inner cylinderShip from California warehouse